Quick 10 Minute Pillowcase

Posted by Kim Rivadeneira on

Need a quick gift? Want to give your bedroom set a refresher? This 10 Minute Pillowcase is for you! 

You'll need a 22" by WOF (width of fabric that is minimum ~58" wide) WOVEN fabric for EACH pillow case. 

In this tutorial we are using the "Main Street Sweets Border Print" in Woven. 

STEP 1: You should be starting with a 22" x WOF piece with the border running along the short edges.

 STEP 2: Trim the selvage off the short edges. I measured 5" from the bottom of the pink scallops to ensure the edges would be even. 

STEP 3: Finish the short edges. Placing the fabric face down, fold up 1/4" on the short edge and iron. Fold over again 1" and iron. Top stitch making sure you catch the fabric underneath. 

STEP 4: With the fabric face up, fold the fabric right sides together bringing the short edges together. Pin the long edges together and sew together. I recommend using a serger to finish the long edges. 

STEP 5:  Flip right side out, give it a little ironing, and you're done!

 


Share this post



← Older Post Newer Post →


0 comments

Leave a comment

Please note, comments must be approved before they are published.